Colour a small piece of gum paste green for the leaves . Cut the floral wire into 4 pieces, keep 3 wires normal. Roll small balls (+/- 0.5 cm), make two cones and press it flat. Put a piece of floral wire as the glue and stick it in the paper . Use a knife, to create a vein in the middle of the leaf. Make 16 leafs.

Make small balls pink and put the buttons on a wire. Colour the rest of the gum paste pink. Make 12 small white balls, and insert a wire with a little glue, let dry. If they are hard roll out the pink gum paste thinly and cut out 12 flowers with the plunger. Put them on the thick foam flower and push a little with the boll tool. Put them on the flowers wires with white balls. Make a small ball and press it behind the flower.

Allow everything to dry for at least two days. Cut the flower tape into two narrow strips. Stretch them out so the glue comes off and turn them over the flowers wires under the flowers , buds and leaves. The tape is approx. 4 cm. Then form twigs of it.

Cut out 3 petals per cutter to make the rose. Put them on the thin foam flower and make the edges thin with the bone tool. Press firmly on the gum paste so that the edges become wavy. Insert the floral wire (20 g) in the smallest pink base. Apply glue to the button and stone in the smallest outstretched rose. Roll the sheets on the button. Always do a little glue on the bottom and sides of the petals. Do the same with the other two smallest, every flower a little looser. Hang upside down to dry slightly. Then connect all other rose petals to the wire, from small to large, with a little glue on the center. Note that the petals still shingled jump. At last, cut out the calyx leafs and attach them under the rose. Tape the floral wire which extends below the rose. Press a flower pic in the cake or dummy, first insert the sprigs and then the rose.